Max Bond Original Construction Adhesive 320g
Part Number: X-MAXB
Max BondTM Construction Adhesive is a synthetic, rubber based adhesive designed primarily for the installation of flooring and wall panels.
Max BondTM Construction Adhesive is also ideal for bonding most common construction materials such as metal, timber and concrete.
- Bridges wall gaps, effective when used on uneven surfaces
- Reduced squeaking associated with nail ride in floors
- Multipurpose
- Repositionable for up to 20 minutes after application
- Water resistant
- High bond strength
Technical Details
- Box Quantity:
- 20
- Colour:
- Light Tan
- Single Units:
- Yes
- Weight:
- 320g
Product Information
Max BondTM Construction Adhesive is a synthetic, rubber based adhesive designed primarily for the installation of flooring and wall panels.
Max BondTM Construction Adhesive is also ideal for bonding most common construction materials such as metal, timber and concrete.
- Bridges wall gaps, effective when used on uneven surfaces
- Reduced squeaking associated with nail ride in floors
- Multipurpose
- Repositionable for up to 20 minutes after application
- Water resistant
- High bond strength
[ Substrates ]
- Ceramic
- Plywood
- Cement Sheet
- Metal
- Concrete
- MDF
- Timber
- Fibreglass
- Brick
- Aluminium
- Plasterboard
Not recommended for: mirrors on ceilings, freshly painted surfaces, waterproofed surfaces, wallpaper, copper based material, constant water immersion, vinyl backed mirrors with safety backed film.
[ Uses In ]
- Installing particle board, fibre cement, plasterboard, plywood and strip flooring to joists
- Bonding fibre cement sheet, plaster board and wall panelling to timber and metal studs
- Skirting boards, architraves and trims to walls
- Mirrors to vertical walls
- Replacing loose tiles on walls (not recommended for floor tiles)
[ How to ]
All surfaces must be clean and free from dust, oil or other contamination. Sand painted surfaces.
Application: Cut off tip of cartridge and pierce inner foil seal, cut nozzle to desired size. Fit Nozzle to cartridge. Use continuous wavy beads spaced at 40cm intervals along flat surfaces, joists, battens or studs. Within 10 minutes, fit surfaces together and press firmly. Can be repositioned for up to 20 minutes. If bond is under immediate stress, support or clamp until a strong bond develops.
In heavy load applications e.g. subfloors, use nails or screws in addition to Max Bond Construction Adhesive. For faster bonding and for mirrors, apply to one surface only, press together, tilt panel back to allow solvent to escape then brace until set. For bonding mirrors apply a 5mm wide bead every 20cm. Do not apply in blobs.
