Close

Battery Powered Home Smoke Alarms

Wall Mount Test/Locate/Silence/Memory Control (10-year Lithium battery)View larger

Wall Mount Test/Locate/Silence/Memory Control (10-year Lithium battery)

P-EIB450

The Brooks Wall Mount Test/Locate/Silence/Memory Control has the following features:

  • Designed for use with Brooks RadioLINK™ enabled alarms, bases & accessories
  • Low battery power warning
  • House codes to limit control to specific systems
  • One button within easy reach to control and communicate with your alarm system
  • Stylish, aesthetic design with wall mount plate
  • No wiring required (10-year Lithium battery)

The Brooks Wall Mount Test/Locate/Silence/Memory Control has the following features:

  • Designed for use with Brooks RadioLINK™ enabled alarms, bases & accessories
  • Low battery power warning
  • House codes to limit control to specific systems
  • One button within easy reach to control and communicate with your alarm system
  • Stylish, aesthetic design with wall mount plate
  • No wiring required (10-year Lithium battery)

Downloads

TECHNICAL DATA SHEETS
MANUAL

Technical Details

  • Approvals : AS/NZS4268:2012
  • Brand : Brooks
  • Carbon Monoxide : No
  • Heat : No
  • Ionisation : No
  • Low Battery Warning Alert : No
  • Mains Powered : No
  • Photoelectric : No
  • Series : 600 Series
  • Test/Reset Button : No

Product Information

The P-EIB450 controller provides for an effortless method of testing, silencing and locating triggered smoke alarms without the need to reach up to the alarms on the ceiling.

P-EIB450

The alarms systems can be tested when in standby mode (when the alarm is active and sensing, but not triggered).

When the alarm system is triggered, the P-EIB450 offers the following control functions in sequence for the user’s convenience:

  • With the alarms sounding, the P-EIB450 will be flashing the “Silence” indicator. Pressing the button on the P-EIB450 will silence all the alarms in the interconnected system, with the exception of the alarm that initiated the triggering event (the alarm that detected heat or smoke). All remaining alarms will now be silenced for a period of 10 minutes. The “Locate” indicator will start flashing indicating that the system is now in “Locate” mode. 
  • With the system in “Locate” mode, only a single alarm will be sounding. Pressing the button on the P-EIB450 while the “Locate” indicator is flashing will now silence the triggered alarm. All alarms will now remain silent until the original 10-minute silence time has expired. It should be noted that during the silence period, should a smoke detector that had not initially detected smoke sense smoke, it will alarm regardless of the “Silence” mode as this is a new smoke detection event. The P-EIB450 will now return to the normal standby status.
  • The “Test” function - from the standby mode (no LED’s on or flashing), the button may be depressed and held for a second to test a smoke alarm system. All connected smoke alarms should sound for a few seconds before falling silent again.
  • The “Memory” function is an alarm retaining feature of the P-EIB450 in the event of an alarm condition occurring and no interaction with the system during the event (i.e. no buttons were pressed). Once all the alarms have reset, the P-EIB450 retains a memory of which alarm triggered the event. By pressing the button while the “Memory” indicator is flashing will cause the triggering alarm to sound, much like the “Locate” feature.

 

People Also Bought

29 other products in the same category

Close